Product Portrait
Servo pump
Suitable for: Scania
Further links
Similar articles from the product range of the brand DT Spare Parts
Note: Accessories are listed on the respective article detail page in the Partner Portal.
Tips & Tricks
The equipment must be checked before the article is replaced. If a high water content or dirt particles are detected, the equipment must be replaced. In case of heavy soiling, the hydraulic system should be rinsed as described in the assembly instructions supplied with the article. The mounting surface must be cleaned. If sealant is used during assembly, it is important that no sealant enters the operating fluid circuit.
The erection screws must be mounted with the torque specified by the manufacturer. The connections should be installed by hand to prevent damage to the thread. Now ventilate the system: The steering wheel must be turned three times to the left and three times to the right when the front axle is raised. During the subsequent test run, the leakage check must be carried out and the level of the equipment must be corrected.
Structure of the servo pump
- Ball bearing
- Drive shaft
- Shaft sealing ring
- Thrust washers
- Rotor
- Rotor blades
- Aluminium housing
- Control valve